Enable or Disable Sequence Numbers

To enable or disable the "N" numbers in a generated program, start by going to "Settings", and down to "Machine Definition Manager".

Next go to the "Control Definition"

In the "Control Topics" tree on the left, go to "NC Output" and enable the sequence numbers by putting a check in the box next to "Output Sequence Numbers" and disable it by removing the check.

(Note: This is where you can choose what number the sequence start on, and the increment it goes by)

Click on the disk to save your settings, then click on the green check when finished. 

(Note: Clicking on the green check will prompt you to save these new settings)

Save your settings in the "Machine Definition Manager", and click on the green check.

• Related Articles

• Setting Defaults in the Control Definition

  The post processor is made up of 3 files, and the solution is going to go into the Control Definition. First with the post processor you want to work on loaded, go to the Machine Tab and then into the Machine Definition Manager. Once the Machine ...

• Mastercam Software Licensing Guide

  Mastercam Software Licensing Guide This help topic covers the installation, updating, and administrating of Mastercam's software license. Mastercam is a protected software and requires a license to run. The software license is digital and is managed ...

• Post Processor Information

  A post processor is made up of 3 main files, the Machine Definition, the Control Definition, and a PST file. (You will get a PSB file if the post is a custom post.) The Machine Definition is the machine's kinematics and limit settings. There is other ...

• 5 Axis Cube Test

  Things to know: The attached cube test is setup for a 5 axis table/table mill that tilts to the left The X0, Y0, and Z0 is the bottom center of the part, and it's not based on the machines center of rotation The tool numbers can be changed, along ...